Temp cycling chamber


GL series introduction: this chamber is suitable for the product (complete machine), parts, materials to perform high temperature test, low temperature test and high&low temperature cycling test (cooling start point from high temperature ≤90℃). This chamber cannot be used for the test of heat emission samples. And when the temperature is higher than 90℃, the refrigeration system of the chamber cannot be opened for the cooling requirement.
 
 
 GL4 series detailed parameters
Type GL401F GL4025F GL405F GL41F
Performance parameters Temperature range -40℃~150℃
Temperature fluctuation ≤1℃(≤±0.5℃, according to GB/T5170-1996)
Temperature deviation ±2℃
Heating up time(room temperature →+150℃) ≤60min ≤65min ≤65min ≤80min
Cooling down time(room temperature→-40℃) ≤70min ≤75min ≤90min ≤80min
Structure Shell Cold-rolled steel plate with two-sided electrostatic spray powder(ivory)
Inner wall material Stainless steel plate
Thermal insulation material Rigid polyurethane foam
Refrigeration Refrigerating method Air cooling
Refrigerator Imported compressor
Observation window 200×270mm
(W×H)
300×400mm
(W×H)
400×500mm
(W×H)
Test hole One, at the left side two, one at the left and the other one at the right
Inner dimension(mm) D 400 600 700 1020
W 500 600 800 950
H 550 670 870 1070
External dimension(mm) D 1290 1470 1675 2015
W 700 800 1000 1150
H 1712 1660 1860 2060
Installed power 4KVA 6.3KVA 8.5KVA 11KVA
Power supply 380V±10%,50Hz±1 three phase four wire + ground wire and grounding protection resistance is less than 4Ω
 
 
 
 
GL6 series detailed parameters
 
Type GL601F GL6025F GL605F GL61F
Performance 
parameters
Temperature range -70℃~150℃
Temperature fluctuation ≤1℃(≤±0.5℃, according to GB/T5170-1996)
Temperature deviation ±2℃
Heating up time(room temperature →+150℃) ≤60min ≤65min ≤80min ≤70min
Cooling down time(room temperature →-60℃) ≤60min ≤80min ≤80min ≤80min
Structure Shell Cold-rolled steel plate with two-sided electrostatic spray powder (ivory)
Inner wall material Stainless steel plate
 
Thermal insulation material Rigid polyurethane foam
Refrigeration Refrigerating method
 
Air cooling
Refrigerator    Imported compressor
Observation window 200×270mm
(W×H)
300×400mm
(W×H)
400×500mm
(W×H)
Test hole One, at the left side two, one at the left and the other one at the right
Inner dimension(mm) D 400 600 700 1020
W 500 600 800 950
H 550 670 870 1070
External dimension(mm) D 1290 1470 1675 2015
W 700 800 1000 1150
H 1712 1660 1860 2060
Installed power 5.5KVA 7KVA 10KVA 12.5KVA
Power supply 380V±10%,50Hz±1 three phase four wire + ground wire and grounding protection resistance is less than 4Ω

Chongqing Yinhe Experimental Equipment CO.,LTD. 2012 渝ICP备09054543号 技术支持:Hansa Power by DedeCms
XML 地图 | Sitemap 地图